I wanted to share a tip on something that I ran into, on how to fit your fin properly in the fin box on your board. The Carbon fins have a bit of extra carbon fibre on them at the top part / (Base) of the fin (which sits in the fin box). If the base of your fin fits proud of the box and not flush, you just simply need to shave it down. I did this just by grinding it (sliding back and forth on the ground) on the pavement in my drive way, buy you could also use sand paper / grinder. Start off easy and then fine tune it for your specific box, ending up with a super sweet custom fit!
Hope this helps.
Best place to talk about Fins, Windsurf, SUP & Kitesurf
1 post • Page 1 of 1